Toe links are catching quite a lot of dust and dirt from below the car.
To protect the rod end spherical bearings from getting dirty and wearing out prematurely, we advise to install these Nitrile boots.
While others use standard rubber boots, we’ve decided to use the more expensive Nitrile based boot.
The big advantage of these Nitrile boots is that they are easy to install (you will not tear these open at installation) and because they are a lot more flexible than the rubber items, they will last much longer!
Clean the rod end bearings before installation. Then install the boots.
When you’re using our bearings, you don’t need to grease them. However, we usually put a little puff of ACF50 on each side of the bearings to protect the non moving parts from corrosion.